3 Transport, storage, assembly
B 1000 en-3921 23
The transverse force must be applied as closely as possible to the gear unit. For drive shafts with free
shaft ends (Option W), the maximum permissible transverse force F
R1
applies for the application of the
transverse force to the centre of the free shaft journal. For output shafts, the application of the
transverse force F
R2
must not exceed the dimension x
R2
. If the radial force F
R2
is stated on the name
plate, but no dimension x
R2
is stated, application of force is assumed to be to the centre of the shaft
journal.
Figure 3: Permissible application of force to drive and driven shafts
To Next Page
Loading...