3 Transport, storage, assembly
B 1000 en-3921 31
Clean all individual components before refitting. Check the bushes and the shrink disc for damage or
corrosion. Replace the bushes and the shrink disc if they are not in perfect condition. Coat the conical
seat of the outer rings and the outside of the clamping ring with MOLYKOTE® G-Rapid Plus or a
similar product. Place some multi-purpose grease on the screw thread and the contact surfaces of the
screw heads.
3.9 Fitting the covers (option: H, H66)
Use all fastening screws. Secure the fastening screws by coating them with securing lubricant, e.g.
Loctite 242, Loxeal 54-03. Tighten the fastening screws with the correct torque (see chapter 7.3
"Screw tightening torques").
For covers with Option H66, press in the new condition closing cap by tapping it lightly with a hammer.
Figure 13: Fitting the covers, Option SH, Option H, and Option H66
To Next Page
Loading...