Nord Drivesystems B 1000 - Figure 5: Removing the Factory-Fitted Closing Cap; Figure 6: Gear Unit Mounted on Shaft with a Shoulder Using the Fastening Element; Figure 7: Gear Unit Mounted on Shaft Without a Shoulder Using the Fastening Element; Figure 8: Removal Using Dismantling Device

3 Transport, storage, assembly
B 1000 en-3921 25
Figure 5: Removing the factory-fitted closing cap
The gear unit can be fitted to solid shafts with and without a shoulder using the fixing element
(Option B). Tighten the fastening element bolt with correct torque (see chapter 7.3 "Screw tightening
torques").
When fastening without a contact shoulder, a circlip is used in the hollow shaft for axial fastening.
Figure 6: Gear unit mounted on shaft with a shoulder using the fastening element
Figure 7: Gear unit mounted on shaft without a shoulder using the fastening element
A gear unit can be removed from a shaft with a shoulder e.g. using the following device.
Figure 8: Removal using dismantling device