What to do if Nord Drivesystems Industrial Equipment has a shock when switching on and vibrates?
If you experience a shock when switching on your Nord Drivesystems Industrial Equipment accompanied by vibrations, check the following: * If the motor coupling is defective, replace the elastomer ring. * If the gear unit fastening is loose, tighten the motor and gear unit fastening screws. * If the rubber element is defective, replace it.
Why does the gear unit of my Nord Drivesystems Industrial Equipment become too hot?
If your Nord Drivesystems Industrial Equipment's gear unit becomes too hot due to unfavourable installation conditions or gear unit damage, consult the NORD Service department.
What to do if oil is escaping from the gear unit or motor of my Nord Drivesystems Industrial Equipment?
If oil is escaping from the gear unit or motor of your Nord Drivesystems Industrial Equipment, this may indicate a defective seal. In this case, consult the NORD Service department.
Guidelines on proper product usage and prohibited modifications for safety.
Specific safety instructions for activities like transport and installation.
Details various potential hazards associated with gear unit operation.
Comprehensive list of gear unit types and their corresponding designations.
Detailed breakdown of information presented on the gear unit's type plate.
Steps to prepare the gear unit and installation site before mounting.
Correct procedures for mounting and aligning the gear unit.
Procedures for fitting shrink discs and GRIPMAXX™ on shafts.
Procedures for attaching standard IEC or NEMA motors.
Procedures for verifying the oil level before the gear unit is put into operation.
Steps to activate the automatic lubricant dispenser for roller bearings.
A checklist to ensure all steps are completed before final commissioning.
Schedule of recommended service and maintenance intervals for gear units.
Detailed instructions for performing various service and maintenance tasks.
Tables detailing compatible lubricants and their quantities for various gear unit types.
Critical technical data including screw tightening torques and leak definitions.
Guidance on diagnosing and resolving common gear unit faults and repair procedures.
General| Frequency | 50/60 Hz |
|---|---|
| Control Method | vector control |
| Communication | Modbus, CANopen, Profibus |
| Power | 160 kW |
| Voltage | 480V |
| Efficiency class | IE2 |
| Protection class | IP20 |
| Mounting | Wall |
To Next Page
