7 Appendix
B 1000 en-4419 65
Pos: 374 /A nleit ung en/G etr ieb e/7. A nha ng/Sc h miers tof fme nge n [B 100 0]_T itel + Ei nl eit ung @ 2 3\mod_1531925515538_388.docx @ 2434431 @ 2 @ 1
7.3 Lubricant quantities
Information
After changing the lubricant, and in particular after the initial filling, the oil level may change during the
first few hours of operation, as the oil galleries and the hollow spaces only fill gradually during
operation.
The oil level is still within the permissible tolerance.
If at the express request of the customer, an oil inspection glass is installed at an additional charge,
we recommend that the customer corrects the oil level after an operating period of approx. 2 hours, so
that when the gear unit is at a standstill and has cooled down, the oil level is visible in the inspection
glass. Only then, is it possible to check the oil level by means of the inspection glass.
The filling quantities stated in the following tables are for guidance only. The precise quantities vary
depending on the exact gear ratio. When filling, always observe the oil level screw hole as an
indicator of the precise quantity of oil.
Gear unit types SK 11282, SK 11382, SK 11382.1, SK 12382 and SK 9096.1 are normally supplied
without oil.
Pos: 37 5 /Anlei tung en/G etrieb e/7. A nhang /Sch mierstof fme ngen [B 1000] @ 23\mod_1531925097811_388.docx @ 2434387 @ 5555555 @ 1
To Next Page
Loading...