Nord Drivesystems B 1000 - Fitting the Covers; Fitting a Standard Motor (Option: IEC, NEMA, AI, AN); Figure 14: Disassembly and Assembly of the Cover Cap; Table 5: IEC and NEMA Motor Weights

Gear units – Manual with installation instructions
32 B 1000 en-3921
3.10 Fitting the covers
Some versions of universal worm gear units are delivered as standard with a plastic cover cap. The
cover cap protects the radial shaft seals against the entry of dust and other contamination. The cover
cap can attached on the A side or the B side. It can be removed by hand without tools.
NOTICE
Damage to the expansion elements of the cover cap
• Do not jam the cover cap when pulling it off or attaching it.
Pull the cover cap off vertically prior to the installation of the universal worm gear unit. After completing
the fitting, attach the cover cap onto the right side by attaching the expanding elements into the
threaded holes on the output flange.
Figure 14: Disassembly and assembly of the cover cap
3.11 Fitting a standard motor (Option: IEC, NEMA, AI, AN)
The maximum permitted motor weights indicated in the table below must not be exceeded:
Maximum permitted motor weights
IEC motor size
63
71
80
90
100
112
132
160
180
200
225
250
280
315
Max. motor weight [kg] 25 30 501) 50 802) 80 100
2503
)
250 350 500 1000
1000 1500
NEMA motor size
56C
140TC
180TC
210TC
250TC
280TC
320TC
360TC
4)
360TC
/400TC
Max. motor weight [kg] 30 50 80 100 200 250 350 500 700
Table 5: IEC and NEMA motor weights
1) Maximum of 40 kg permissible for gear units SK920072.1, SK92072.1, SK0, SK071.1 and
SK0182.1
2) Maximum of 60 kg permissible for gear units SK1382NB, SK1382.1, SK92372, SK92372.1,
SK12063, SK372.1, SK371.1
3) Maximum of 200 kg permissible for gear units SK42, SK4282, SK9042.1, SK42125
4) For gear units SK62, SK72, SK73, SK83, SK93, SK9072.1, SK6282, SK7282, SK7382, SK8382,
SK9382