Nord Drivesystems B 1000 - Page 76

Gear units – Manual with installation instructions
76 B 1000 en-3921
Key word index
A
Activating the vent ......................................... 40
Address .......................................................... 74
C
Change the oil ............................................... 49
Check the hose .............................................. 48
Checking the oil level ..................................... 46
Cooling coil .................................................... 42
Cooling system, internal ................................ 36
Covers ........................................................... 31
D
Disposal of materials ..................................... 51
E
Electric motor ................................................. 39
Electrical connection ...................................... 39
F
Fault ............................................................... 72
G
Gear unit types .............................................. 14
General overhaul ........................................... 50
GRIPMAXX™ ................................................ 29
H
H66 option ..................................................... 24
Hollow shaft with GRIPMAXX™ (Option M) .. 29
Hose union .................................................... 71
I
Installation ..................................................... 19
Intended use .................................................. 11
Internet ........................................................... 74
Introduction of forces ..................................... 22
L
Leakage ......................................................... 73
Long-term storage ......................................... 18
Lubricant dispenser ................................. 41, 49
Lubricant quantities ....................................... 68
Lubricants ...................................................... 68
M
Maintenance ................................................. 74
Maintenance intervals ................................... 44
Maintenance work
Check for running noises .......................... 45
Checking the oil level ................................ 46
Leaks ......................................................... 45
Lubricant dispenser ................................... 48
Oil change ................................................. 49
Radial shaft seal ........................................ 50
Re-greasing VL2, VL3, W and AI/AN ........ 48
Vent screw ................................................. 50
Visual inspection ....................................... 45
Motor ............................................................. 39
Motor weights for IEC adapters .................... 32
N
Name plate .................................................... 16
nsd tupH ........................................................ 20
O
Oil level ......................................................... 40
Option M ....................................................... 29
Options .......................................................... 14
P
Pulling device ................................................ 22
Push-on gear unit .......................................... 24
R
Radial shaft seal ........................................... 50
Re-grease the bearings ................................ 50
Re-greasing .................................................. 48
Repairs .......................................................... 74
Roller bearing greases
.................................
. 68
Running noises ............................................. 45
Running-in time ............................................. 43
S
Safety information ......................................... 11
Service .......................................................... 74
Service intervals ............................................ 44