List of illustrations
B 1000 en-3921 9
List of illustrations
Figure 1: Name plate ............................................................................................................................................. 16
Figure 2: Example of a simple pulling device ........................................................................................................ 22
Figure 3: Permissible application of force to drive and driven shafts ..................................................................... 23
Figure 4: Applying lubricant to the shaft and the hub ............................................................................................. 24
Figure 5: Removing the factory-fitted closing cap .................................................................................................. 25
Figure 6: Gear unit mounted on shaft with a shoulder using the fastening element .............................................. 25
Figure 7: Gear unit mounted on shaft without a shoulder using the fastening element ......................................... 25
Figure 8: Removal using dismantling device ......................................................................................................... 25
Figure 9: Mounting the rubber buffer (Option G and/or VG) on parallel shaft gear units ....................................... 26
Figure 10: Attaching the torque support on bevel gear and worm gear units ........................................................ 26
Figure 11: Hollow shaft with shrink disc ................................................................................................................. 27
Figure 12: GRIPMAXX™, exploded diagram ........................................................................................................ 29
Figure 13: Fitting the covers, Option SH, Option H, and Option H66 ..................................................................... 31
Figure 14: Disassembly and assembly of the cover cap ........................................................................................ 32
Figure 15: Fitting the coupling onto the motor shaft - various types of coupling .................................................... 34
Figure 16: Cooling cover ....................................................................................................................................... 36
Figure 17: Connection of the oil/air cooler ............................................................................................................. 37
Figure 18: Position of the oil expansion chamber .................................................................................................. 38
Figure 19: Position of the oil expansion chamber .................................................................................................. 39
Figure 20: Activating the vent screw ...................................................................................................................... 40
Figure 21: Activating the pressure vent screw ....................................................................................................... 40
Figure 22: Removing the vent plug and fitting the special pressure vent ............................................................... 41
Figure 23: Fitting the grease collection container .................................................................................................. 41
Figure 24: Activating the automatic lubricant sensor with standard motor mounting ............................................. 42
Figure 25: Adhesive label ...................................................................................................................................... 42
Figure 26: Checking the oil level with a dipstick .................................................................................................... 46
Figure 27: Re-grease IEC/NEMA adapters AI and AN with option BRG1 ............................................................. 48
Figure 28: Switching the automatic lubricant sensor with standard motor mounting ............................................. 48
Figure 29: Parallel shaft gear units with oil level tank ............................................................................................ 54
To Next Page
Loading...