2 Assembly and installation
BU 0200 GB Subject to technical alterations 23
2.1.2 Adapters for Different Motors
In some cases, the terminal box attachments are different for different sizes of motor. Therefore, it may be
necessary to use an adapter to mount the frequency inverter.
In order to guarantee the maximum protection class IP55 / IP66 of the entire unit, motor must also have a
corresponding protection class.
For NORD motors, as of size 80, the adapter unit can be directly mounted on the motor as standard. For
motors larger than sizes 63-71 it is necessary to use an additional adapter plate and seal. Also, for certain
device configurations with motor sizes 80 - 112 it may be necessary to use an adapter plate and seal.
NORD motor sizes Mounting of SK 200E S I Mounting of SK 200E S II Mounting of SK 200E S III
Size 63 - 71
Mounting with adapter kit I
not possible not possible
Size 80 - 112
direct mounting direct mounting
Mounting with adapter kit II
Size 132 not possible not possible direct mounting
Overview of adapter kits
Name Mounting of SK 200E S I Part No.
Mounting with adapter plate, size 63 – 71 011015410
Adapter Kit I
Additional terminal box frame seal 013097000
Mounting with adapter plate, size 80 – 112 013035490
Adapter Kit II
Additional terminal box frame seal 013097060
Adapter plate, Part No. 011015410
Seal, Part No. 13097000
Motor Size 71
Adapter unit
SK TI4
Important!
The adaptability of motors from other manufacturers must be checked in individual cases!
To Next Page
Loading...
