Need help?Do you have a question about the Nordic nRF9160 DK and is the answer not in the manual?
General| Architecture | ARM Cortex-M33 |
|---|---|
| Frequency | 64 MHz |
| RAM | 256 KB |
| Flash Memory | 1 MB |
| Cellular Connectivity | LTE-M, NB-IoT |
| User Interface | Buttons, LEDs |
| Expansion | Arduino Uno Rev3 compatible headers |
| Operating Temperature | -40°C to +85°C |
| Microcontroller | nRF9160 SiP |
| GNSS | GPS |
| I/O Pins | GPIO, UART, SPI, I2C, ADC |
| Connectivity | UART, SPI, I2C |
| Power Supply | USB or external power |
| Debug Interface | Segger J-Link |
The primary mode for programming and debugging the nRF9160 DK.
Mode for isolating the nRF9160 SiP for current measurement.
Details on the flexible and configurable power supply system of the DK.
Steps to prepare the DK for measuring current consumption.
Method to measure current profile using an oscilloscope.
Method to measure current using a current meter.
To Next Page
