Operation
A 5-17
E 2015 Nordson Corporation
All rights reserved
321222_06
Issued 04/2015
Manual
5. Flush the system with the flushing material recommended by your
adhesive supplier. Drain the system.
Table A 5-6 Draining Methods
Method of Draining
Procedure
Gun 1. Place a suitable container under each
gun nozzle.
2. Remove each nozzle.
3. Press the PUMP key.
4. Set the pump speed to 100 rpm to pump
the adhesive out through the gun.
Manifold Pump the adhesive out through the
manifold. Refer to the filter flushing
procedure for your filter in the Maintenance
section of this manual.
Hoses 1. Disconnect a hose from a manifold return
port.
2. Position the hose over a suitable waste
container and secure it.
3. Press the PUMP key.
4. Set the pump speed to 100 rpm to pump
the adhesive out through the hose.
NOTE: Tighten the pressure control valve
as required to prevent pump cavitation.
5. Refer to Table A 5-7. Check the Safety Data Sheet (SDS) for the
recommended operating temperature of the new adhesive. If the
temperature is different from the old adhesive, reprogram your
processor's temperature settings.
Table A 5-7 Temperature Programming Procedures
Type of Temperature Setting Programming Procedure
Overtemperature setpoint Refer to System Settings Controls
in the Configuration section of this
manual.
SETPOINT or STANDBY
temperature setpoint
Refer to Temperature Controls in
the Configuration section of this
manual.
To Next Page
Loading...
