Nordson FoamMelt 200 - Page 5

Table of Contents
iii
E 2015 Nordson Corporation
All rights reserved
321222_06
Issued 04/2015
Manual
8. Electrical Connections A 3-8...................................
Opening the Electrical Enclosure A 3-8........................
Strain Relief Installation A 3-10...............................
Main Electrical Service A 3-10...............................
Output Contact Connection (Optional) A 3-14..................
Standard Outputs A 3-14..................................
Optional Input/Output Board A 3-17........................
1. Introduction A 4-1.............................................
2. System Settings A 4-4.........................................
3. I/O Board Features A 4-7......................................
4. Temperature Controls A 4-8....................................
Programming Guidelines A 4-9...............................
Temperature Programming Shortcuts A 4-10...................
Individual Zones A 4-10.....................................
All Zones A 4-12...........................................
5. Clock Controls A 4-13.........................................
Setting the Clock A 4-13.....................................
Standby and Heater Times A 4-15............................
Setting Standby and Heater Times A 4-16...................
Deleting Standby and Heater Times A 4-17..................
Deleting an Entire Day A 4-17.............................
Example of Seven-Day Clock Use A 4-18.....................
6. Configuration Charts A 4-19....................................
Setpoint (Operating) Temperatures A 4-19.....................
Standby Temperatures A 4-20...............................
Heaters On/Off Times A 4-21................................
Standby Enter/Exit Times A 4-22.............................
Customized System Settings A 4-23..........................
System Fault Log A 4-24....................................
System Warning Log A 4-25.................................
Section A 4
Configuration