Table of Contents
iv
E 2015 Nordson Corporation
All rights reserved
321222_06
Issued 04/2015
Manual
1. Introduction A 5-1.............................................
2. Temperature Control Setup A 5-1...............................
Seven-Day Clock A 5-2.....................................
Standby Mode A 5-3........................................
Entering Standby Mode A 5-3.............................
Exiting Standby Mode A 5-3...............................
3. Startup A 5-4.................................................
Automatic A 5-4............................................
Manual A 5-4..............................................
4. Pump Speed Adjustment A 5-6.................................
5. Pump Charts A 5-7...........................................
Pump Speed A 5-7.........................................
Viscosity A 5-8.............................................
Density Reduction A 5-8....................................
Circulation to Output Ratio A 5-8.............................
6. Density Control Adjustment A 5-9...............................
Taking a Hot Melt Sample A 5-9..............................
Taking a Foam Sample A 5-10...............................
Density Determination and Reduction A 5-11..................
7. System Pressure Adjustment A 5-13............................
Changing System Pressure A 5-13...........................
8. System Monitoring A 5-14.....................................
Zone Temperatures A 5-14..................................
System Settings A 5-14.....................................
Fault Log A 5-15...........................................
Running a System Test A 5-16...............................
9. Changing Adhesives A 5-16....................................
System Flush A 5-18........................................
10. Shutdown A 5-20.............................................
Automatic Shutdown A 5-20.................................
Manual Shutdown A 5-20....................................
Section A 5
Operation