Nordson FoamMelt 200 - Page 7

Table of Contents
v
E 2015 Nordson Corporation
All rights reserved
321222_06
Issued 04/2015
Manual
1. Introduction A 6-1.............................................
2. System Preparation A 6-1.....................................
Relieving System Pressure A 6-2.............................
Resuming Normal Operation A 6-4...........................
3. Preventive Maintenance Schedule A 6-5.........................
4. Checking Heater Operation Time A 6-6..........................
5. Flushing the Filter Assembly A 6-6..............................
6. Checking the Hydraulic, Gas, and Electrical Connections A 6-7.....
7. Checking and Cleaning the Filter Assembly A 6-7.................
Density Controller and Filter Removal A 6-7...................
Filter Assembly Inspection A 6-10............................
Filter Screen Cleaning and Replacement A 6-11................
Density Controller and Filter Installation A 6-12.................
8. Testing the Pressure Relief Valve A 6-13.........................
9. Flushing the System A 6-14....................................
Pumping Out Old Material A 6-14.............................
Adding New Material A 6-14.................................
10. Checking the Drive Belt A 6-15.................................
11. Maintenance Record A 6-16...................................
1. Introduction A 7-1.............................................
2. Mechanical A 7-1.............................................
3. Pump Outlet Pressure A 7-3...................................
4. I/O Board A 7-4..............................................
5. Wiring Diagrams A 8-1........................................
1. Introduction A 9-1.............................................
2. Hydraulic Repair Guidelines A 9-1..............................
Preparation A 9-1..........................................
Quick-Disconnect Fittings A 9-2..............................
3. Drive Assembly A 9-2.........................................
Preparation A 9-2..........................................
Drive Belt Replacement A 9-2................................
Drive Assembly Removal A 9-4..............................
Removing the Pulleys A 9-4...............................
Removing the Drive Assembly A 9-5.......................
Section A 6
Maintenance
Section A 7
Troubleshooting
Section A 8
Wiring Diagrams
Section A 9
Repair