Normstahl SPARK - Page 38

38
IP2449EN
17.3 Complete menu map
MAIN LEVEL
OM - Operation Mode
PARAMETER LEVEL
AS - Selection of door type
DM - Open direction
AC - Automatic closure enabling
TC - Setting of automatic closing
time [s]
RP - Adjustment of partial opening
measurement [%]
TP - Setting of automatic closing
time after partial opening [s]
PP - Setting of step-by-step se-
quence
TS - Renewal of automatic closing
time after release of safety devi-
ce [%]
WO - Setting of pre-flashing time on
opening [s]
WC - Setting of pre-flashing time on
closing [s]
PK - Parking assistance
RA - Run Adjustment
PARAMETER LEVEL
VA - Opening speed [cm/s]
VC - Closing speed [cm/s]
R1 - Adjustment of thrust on obsta-
cles during opening
R2 - Adjustment of thrust on obsta-
cles during closing
OB - Adjustment of deceleration di-
stance during opening [cm]
CB - Adjustment of deceleration di-
stance during closing [cm]
PC - Adjustment of approach speed
during opening [cm/s]
DC - Setting of disengagement on
stop during closing [mm]
VR - Setting acquisition speed
TA - Adjusting time acceleration in
opening
TQ - Adjusting time acceleration in
closing
TD - Adjusting deceleration time in
opening
TU - Adjusting deceleration time in
closing
DC - Setting of disengagement on
stop during closure [mm]
ST - Adjusting the inrush time
DT - Adjusting obstacle recognition
time
RR - Resetting run calibration values
IO - Input/Output Configuration
PARAMETER LEVEL
R9 - Configuration of input 1-9
T5 - Terminal 5 operation mode
D8 - Selection of device connected
to terminals 1-8
LP - Function of output +LP-
LU - Time to turn on the courtesy
light [s]
LG - Switch-on time for indepen-
dently commanded courtesy light
[min]
BR - Brightness level of the
courtesy light
LR - Electric lock release time [s]
ES - Energy-saving
WS - Setting of Wall Station device
BZ - Buzzer enable/disable