68
/ Administration
4. Press ~ until you have selected the desired
Page Zone
OR
Press -1 until NO appears beside the colon. :
This removes the telephone from all Page Zones.
-_
5. Follow the Exit procedure at the end of this section.
<:
To change the Auxiliary Ringer setting of a telephone:
Begin with 16. Perm i 55 i Q~S 1 on the display, then follow the
steps below.
1.
Press lShowl The display changes to 1 Show Sc t :
2.
1 _
Enter the Intercom Number of the telephone you want to
3.
4.
5.
check. After the final digit is entered, the display
changes to Ful
I handsfrec:
Press I four times. The display shows
Aux. ringer:
1 with aY (Yes)) or N (No) to
indicate whether the Auxiliary Ringer is activated from
the telephone being checked.
Press m to alter the setting. Another press
changes it back.
Follow the Exit procedure at the end of this section.
To set the Call Forward No Answer feature for a telephone:
Begin with 16. Perm i
55
i cln~ 1 on the display, then follow the
steps below.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Press IShow( The display changes to [Show Set:
_ 1
Enter the Intercom Number of the telephone you want to
check. After the final digit is entered, the display
changes to Fu
I I handsfree:
Press m five times. The display shows
(Forward no answr 1
Press ~ The display changes
tolforward to: 1
with the destination set (or None) specified after the
colon.
Press m The display shows 1 Forward to: _ 1
Enter the Intercom number of the telephone to which you
wish to forward calls. The display shows the numbers
after the colon.
Press I[ The display shows
IForward delay: I
with a number to specify how many times a call rings
;.:
before it is forwarded. . .
Press ~ until the appropriate number appears
after the colon.
When you are finished, follow the Exit procedure at the
end of this section.
System Coordinator Guide
To Next Page
