Copyright © 2019 Nortek Security & Control LLC.
25
This changes the system’s status back to System Not
Ready to Arm and moves the sensor to the Sensors Not
Ready list.
System Not Ready to Arm—Sensors Not Ready List
Use the Quick Exit Button
The Quick Exit button gives users the ability to start an
Exit Delay countdown while the system is armed. This
gives users the ability to leave the premises through an
Exit/Entry door, instead of having to disarm and then rearm
the system. When the Allow Quick Exit setting is enabled,
the Quick Exit button appears on the System Armed
(STAY) screen.
NOTE: Consult your installer to determine if the
Allow Quick Exit setting is enabled or disabled on
the system.
To use the Quick Exit button:
1. Arm the system in Stay Moder. See “Arm the
System.”
2. At the System Armed (STAY) screen, tap Quick
Exit.
System Armed—Quick Exit Button
This starts the Exit Delay countdown to give you time to
exit through an Exit/Entry door without having to re-arm the
system. At the end of the countdown, the system arms itself
in the appropriate mode.
In the Event of an Exit Error
If you arm the system and an Exit/Entry door is left in
a violated state or condition at the time the Exit Delay
countdown expires (for example, the door you exit from
doesn’t close behind you), the GC3e Panel sounds the
local alarm and the Entry Delay countdown begins. If
you do not disarm the system when the Entry Delay
countdown begins, the system automatically begins the
alarm transmission sequence. The panel also transmits an
Exit Error report to the Central Station and displays an Exit
Error message on the panel screen, as shown below.
Alarm Transmission & Exit Error Sequence
To Disarm the System
To turn the system’s burglary protection sensors OFF, you
disarm the system. Disarming the system also silences any
type of alarm that might be sounding.
NOTE: To use this feature, you must have an active
user code. See your system’s Master User to obtain
a code.
Disarm the System (Stay Mode)
When the system is armed in Stay Mode, any person with
an active user code can disarm the system.
To disarm the system:
1. At the System Armed screen, tap Disarm.
System Armed > Disarm Button
To Next Page
Loading...
Need help?
General
