Copyright © 2019 Nortek Security & Control LLC
8
Additional Accessories
The installer typically sets up the system to communicate with a variety of wired and/or wireless sensors. Some sensors
are visible on the wall or ceiling. For example, Wireless Smoke/Heat/Freeze Alarms and Wireless Carbon Monoxide
Detectors. Others may be hidden in door jambs. For example, Recessed Door/Window Contacts. Sensors might also be
installed in additional locations. For example, a Glass Break Detector and a Passive Infrared Motion Detector.
NOTE: A variety of 2GIG and GoControl branded devices are compatible with the GC3e Security & Automation
System. Sensors manufactured by other companies may also be compatible with the system. For information, visit
dealer.2gig.com
IMPORTANT: This notation is used to indicate a situation which, if not avoided, could result in property damage,
equipment damage, or data loss.
IMPORTANT: To ensure that the system’s sensors are operating properly, it is important for 2GIG alarm dealers
and system owners to ensure sensor batteries and wireless signals are tested at least once a year.
Depending on the specifi c installation, systems may also be installed with one or more of the following 2GIG accessories:
Kits & Keypads
»
2GIG Control Panel Desktop Kit
»
2GIG SP1 Keypad
»
2GIG SP2 Keypad
»
2GIG PAD1
Radios & Antennas
»
2GIG Cellular Radio Module
»
2GIG External Attic Mount Antenna
Sensors & Peripherals
»
2GIG Thin Door/Window Surface Contact
»
2GIG Recessed Door/Window Contact
»
2GIG Passive Infrared (PIR) Motion Detector
»
2GIG Glass Break Detector
»
2GIG Smoke/Heat/Freeze Alarm
»
2GIG Smoke/Heat Detector
»
2GIG Panic Button Remote
»
2GIG Carbon Monoxide Sensor
»
2GIG Takeover Module
»
2GIG Doorbell
»
Universal Garage Door Receiver
»
2GIG Tilt Sensor
»
2GIG Bypass Sensor
»
2GIG Flood Sensor
»
2GIG Repeater
NOTE: eSeries sensors are only compatiblewith the
GC3e panel.
Z-Wave Smart Home Controls
Consult your 2GIG alarm dealer for information about installing a wide variety of compatible Z-Wave smart home controls
including:
»
Lights
»
Locks
»
Thermostats
»
Garage Door Controllers
Setup and Installation
The GC3e Security & Automation System must be installed by a qualifi ed technician who is either employed by, or
under contract with, a 2GIG alarm dealer. The alarm must always be installed in accordance with your country’s national
electrical installation regulations and/or all applicable codes in the local jurisdiction.
Operational Concepts
Understanding these concepts will help you operate the system:
24-Hour Alarm Buttons
An installer can confi gure the GC3e Panel to show or hide three 24-hour alarm buttons on the touchscreen: Panic, Fire,
and Emergency. When the buttons are enabled and visible, users can manually trigger an alarm from the GC3e Panel.
Alarms can also be activated from a wireless keypad (if installed), from wireless sensors, or from portable devices (for
example, a Panic Button Remote). See “Emergency Features.”
To Next Page
Loading...
Need help?
General
