SR1001 Installation Guide
Version 8.3.5
27
4
C
ONFIGURATION
This chapter describes how to login, change the default password, configure the router and
users, and change the factory default configuration. The boot process and software upgrade
process is also discussed in detail.
Logging In
If you have not established a local console connection, see Operator Interface on page 24 for
more information.
The following figure shows the login sequence and the initial prompt after login is complete.
Figure 19 Initial CLI Prompt
NOTE: The default host name is Nortel.
Command Tips
Use the following command tips and shortcuts with command line interface commands.
To display all commands, type tree.
To access help associated with a command, type help <command name>. You may also use
the ? key after any command.
To exit back one level in the command hierarchy, type exit and press Return.
To exit the command mode and/or return to the base CLI prompt, press the key
combination Ctrl-Z.
Type the first two letters of a command, and then press the Ta b key to automatically spell
out the command.
Scroll through the available commands using the Tab key.
Ethernet Configuration Tip
To avoid Ethernet mismatch problems, the SR1001 and the network device to which it is
attached should both be configured identically for speed and duplex. For example, if the
router is configured for auto-negotiation and the far end is configured manually, the router
Initial CLI Prompt
login: username
password:
username logged in on Fri August 6 05:28:01 2004
from console
To Next Page
