Nortel SR1001 - Interface Configuration

41
SR1001 Installation Guide
Version 8.3.5
Interface Configuration
The following are examples of T1, CT3, and DS3 interface configurations. To scroll through the
options available at any command prompt, press the Tab key. For descriptions of the options
available at any command prompt, type help and press Enter.
E1 Interface
Router> configure term
Router/configure> module e1 4
Router/configure/module/e1 4> clock_source line
Router/configure/module/e1 4> framing crc
Router/configure/module/e1 4> exit 2
Router/configure> cabletype monitor_port 1 twisted_pair
Router/configure> module e1 4
Router/configure/module/e1 4> linecode hdb3
Router/configure/module/e1 4> yellow_alarm gen_det
Router/configure/module/e1 4> exit 3
T1 Interface
Router> configure term
Router/configure> module t1 4
Router/configure/module/t1 4> clock_source line
Router/configure/module/t1 4> framing esf
Router/configure/module/t1 4> linecode b8zs
Router/configure/module/t1 4> yellow_alarm gen_det
Router/configure/module/t1 4> exit 3