Chapter 6 - Understanding the Waypoints Function
957 Operator’s Manual, Rev. B Page 79
to that point are in the receiving unit (be aware that a particular route may
not comprise all of its waypoints due to the transfer interruption). Press
the
START
key again to re-start the entire transfer process (this means
that all waypoints and routes, not just the ones already in the receiving
unit and the ones left to be transferred, are re-transferred).
1. Choose the unit you’d like to use as the master.
Remember: You can use either of the two units because
both units are capable of importing or exporting
waypoints and routes. Make sure the second unit is on.
2. At the master unit, press the WAYPTS/ROUTES key to
display the WAYPOINTS AND ROUTES screen.
3. Press the IMPORT/EXPORT menu key to display the
IMPORT/EXPORT screen.
To Next Page
Loading...
