NorthStar 957 - Going to a quick waypoint now

Chapter 1 - Getting Started
957 Operator’s Manual, Rev. B Page 15
the KEYPAD to enter the desired speed, then press the ENTER
key to start going to the demo cursor location.
To go back to the CHART screen (but stay in demo mode),
press the RETURN key twice. The word DEMO always appears
on the CHART screen when you’re in demo mode.
To exit demo mode, on the DEMO CHART screen, press the
EXIT DEMO key. This immediately returns you to the CHART
screen.
NOTE:
Video image display, chart rotation, and zooming in and out all work nor-
mally on the
DEMO CHART
screen.
Going to a quick waypoint now
You can point to any location on the CHART screen and go
right to it. This is called “point-and-shoot” navigation, which
can be the easiest and most powerful way to go to a waypoint:
Just select different locations and go to them, one at a time,
right on the chart. This way of navigating provides the most
flexibility in deciding where you want to travel. Simply move
the cursor wherever you want, press a key, and you’re
navigating.
1. Press the CHART function key to display the CHART
screen.
2. Move the cursor to the desired chart location by pressing
the CURSOR PAD in the lower right corner of the 957.
3. Press the GO TO CURSOR menu key at the lower right of
the screen.