Panel Operation
44 AFP-2800/2802 Manual – P/N 11249 11-Mar-08
6.3.3.13 SERVICE MENU – LIST – LIST – NETPOINT
This screen lists all the network points in the system. Network points are points that are used in scripts acting
between network nodes. Netpoints programmed on remote nodes will be preceded by a node number whereas
the local Netpoints will not have a node number. Any script which uses points from a remote network node may
only contain Netpoints from that node and can not include other remote devices.
E.g.
L1M1 = N10.NP1 OR N20.NP120 OR NP5; is correct
L1M1 = N10.L1D1 OR N20.Z1; is WRONG
Note: AFP-2802 does not support networking. Netpoints can still be programmed and used locally similar to Virtual
Points.
The display shows the point number and the point description.
Active points are denoted by an ‘X’ after the point description.
NP1 COMMON ALARM ON NODE 1 X
NP2 UNNAMED POINT
NP3 UNNAMED POINT
NP4 UNNAMED POINT
NP5 UNNAMED POINT
NP6 UNNAMED POINT
NP7 UNNAMED POINT
NP8 UNNAMED POINT
NP9 UNNAMED POINT
NP10 UNNAMED POINT
NP11 UNNAMED POINT
NP12 UNNAMED POINT
NP13 UNNAMED POINT
NP14 UNNAMED POINT
NP15 UNNAMED POINT
NP16 UNNAMED POINT
NETWORK POINT LIST
F = 0
I = 0
N = 1
BACK
DAY MODE
Actions:
Use the UP and DOWN buttons to scroll through
Virtual points.
Pressing the CHANGE button will take you to the
modify point screen (refer page 61).
Pressing the BACK button will return you to the list
menu screen.
Note: You can also use the arrow keys, the Page Up and Page Dn keys on an external keyboard for scrolling
functions.
To Next Page
Loading...
Need help?
General
