Page 28
INERTIA-2464
Technical & Programming Manual
Copyright (c) 1996,
INERTIA FIRE SYSTEMS
OUTPUT RELAYS
Relays can be programmed to simulate: -
•
Isolate Relay
•
ACF Output
•
Brigade Relay #1
•
Brigade Relay #2
•
Fault Relay
•
Mains Fail Relay
•
General Alarm Relay
•
Bell Output
•
Door Holder Relay
•
Door Switch
•
Reset
Or Can Be Used To:
•
"MAP AND" Up To 5 Zones in Alarm
•
"MAP OR" Up To 5 Zones in Alarm
•
“FAULT MAP” Up To 5 Zones in Fault
•
“MAP ISOLATE” Up to 5 Zones in Isolate
•
“MAP ISO/FAULT” Up to 5 Zones in Isolate/Fault
DEFAULTS
ACF OUTPUT NON-LATCHING, NORMALLY DE-ENERGISED
ALARM VERIFICATION (AVF) 3 MINUTES
TIME 1/1/11 11:11
ZONE TYPES STANDARD LATCH 2S
ZONE OUTPUT CONFIG I-B-G-A-BR1 & BR2
RELAY MAPPING MAP -OR-, MAPPING = 1 TO 1
IE: RELAY 1 = ZONE 1, RELAY 2 = ZONE 2 .............
The
2464
PANEL is self-configuring on power-up therefore it is not necessary to program the number
of zone expansion boards fitted.
To Next Page
Loading...
