Nova Florida DELFIS Monothermal - 3 Instructions for the Installer; Installation Standards; Choosing Where to Install the Boiler

23
Instructions for the installer
3. Instructions for the installer
3.1 Installation standards
This boiler must be installed in compliance with the laws and standards in force in the country of installation, which are herein considered as
entirely transcribed.
To nd out about the gas category and technical specications, refer to operation data and general features specied in the previous pages.
DANGER
Accessories and spare parts for installation and service procedures are to be supplied by the Manufacturer.
Should non original accessories and spare parts be employed, boiler proper performance is not guaranteed.
3.1.1 Packaging
Boiler is shipped in a sturdy cardboard box.
Remove boiler from cardboard box and check its integrity.
The packing materials can be recycled. Disposal must be managed via appropriate waste collection sites.
Keep packaging out of reach of children, as it may be dangerous.
The manufacturer shall not be held responsible in case of damage to people, animals, or property due to failure to follow the above mentioned
instructions.
Packaging includes one plastic bag containing:
• boiler installation, use and maintenance manual;
• the template for mounting the boiler on a wall (see Fig. 5 Paper template).
• 2 screws and relevant wall blocks for xing the boiler to the wall;
3.2 Choosing where to install the boiler
The following must be taken into account when choosing where to install the boiler:
• indications contained in paragraph Air intake and ue gas venting system on page 25 and its sub-paragraphs.
• check the wall for sturdiness, avoiding weak areas.
• do not install the boiler over appliances which may aect boiler operation (e.g. cookers, which produce steam and grease, washing
machines etc.).
• Do not install natural draught boilers in locations with a corrosive or very dusty atmosphere, such as hairdresser salons, laundries etc., as
this may severely reduce the lifespan of the components of the boiler.
• do not install boilers in locations with a corrosive or very dusty atmosphere, such as hairdresser salons, laundries etc., as this may severely
reduce the lifespan of the components of the boiler.