GROUP A/B Button
Although there are only 11 knobs and 11 buttons visible on the Xio, there are in actual fact double
that amount available for edit; two Groups (A and B) mean that there are a total of 22 knobs and 22 buttons
accessible. The Xio will default to Group A, as indicated by the top LED being illuminated. Simply press
the GROUP A/B button to activate the second group of knobs/buttons (the LED below will light to show that
Group B is activated), all 11 knobs and all 11 buttons will now have a different function (in preset Templates)
or can now be assigned completely different parameters within the User Template (if building your own).
Display of X / Y TouchPad controls
In PLAY mode, when the touchpad is pressed the display will show:
XXX is the actual value being sent. For example, if the high value has been set to 10 and the low value 3,
then a value between 3 and 10 will appear. XXX will show ‘Off’ if that control within the Touchpad is not activated.
Both the X-axis (horizontal) and Y-axis (vertical) can be assigned up to two parameters, shown by X1/X2 and
Y1/Y2. For example, filter fr
equency and delay time could both be set to the X-axis, whilst filter r
esonance and
delay feedback are both assigned to the Y-axis. Alternatively, just one control could be assigned to one axis if a
simpler function is required.
X1 = XXX Y1 = XXX
X2 = XXX Y2 = XXX
Press to switch between Group A and B (this means that you have
double the amount of assignable controls available in each Template)
To Next Page
Loading...
