Edit Menu Page 4 –Jump or Pickup Mode
Here, XXX = Pickup or Jump, representing the two types of pot (knob) behaviour. Pickup mode means that
the knobs only transmit MIDI data once they have passed through the value of MIDI data set to that control
in the currently selected Template, whereas Jump mode transmits MIDI data as soon as the knob is rotated.
Edit Menu Page 5 –Control LOW value setting
XXX can be set to a value between 0 and 127 or -64 and +63 (depending on how Page 3 of this Menu is
set) using the DATA encoder. This is the minimum value of the control, which will often be 0 or -64 but in
the case of wanting to set a control to vary from 20 to 30, it would be 20.
Edit Menu Page 6 –Control HIGH value setting
XXX can be set to a value between 0 and 127 or -64 and +63 (depending on how Page 3 of this Menu is
set) using the DATA encoder. This is the maximum value of the control, which will often be 127 or +63 but
in the case of wanting to set a control to vary from 20 to 30, it would be 30.
If this value is set to be lower than the Low Value on the previous Menu Page then the control will effectively
be reversed. For example, rotating the knob clockwise would reduce the value.
Edit Menu Page 7 – Button Type Selection
This Page allows you to select the way the button will behave, with XXX selectable as either Normal,
Momentary, Toggle or Step using the DATA encoder.
Pot/Slider Control:
XXX
Low Value:
XXX
High Value:
XXX
Button Type:
XXX
To Next Page
Loading...
