Using a Sustain Footswitch
A Sustain Footswitch socket on the rear panel can be used to plug in a pedal to sustain notes, in a similar
manner to the sustain pedal on a piano. This pedal is set to CC number 64 in the Factory preset Templates
but can be changed in the same way as any other assignable control (by pressing the pedal whilst in EDIT
mode and then stepping through the pages of available parameters).
In PLAY mode, the display will show the following when the footswitch is activated (providing no edits have
been made to its function):
The value on the far left shows 127 to signify that the footswitch has been activated and is now ‘On’.
There are two settings, ‘On’ (127 is transmitted) and ‘Off’ (0 is transmitted).
In EDIT mode, the data assigned to the footswitch can be changed as with any assignable control. Simply
press the EDIT button once to enter individual Template Edit mode (the LED to the left of the button will
illuminate continuously, not flash) then press down on the footswitch to call up the first page of the Edit
menu for that control.
Sustain Pedal
127 CC64 1 U
To Next Page
Loading...
