Editing an individual onboard Template
After the EDIT button has been pressed once to activate the Template Individual Edit Menu (the LED to the left of
the button will be illuminated continuously), the MIDI data assigned to Knob 1 (in Group A or B, depending on which
is selected) will be displayed on the LCD screen. Pressing/rotating/moving any of the Xio’s controls will call up the
MIDI data for that particular control for editing on the LCD screen, by stepping through the pages of the Template
Individual Edit Menu. The first option in the Template Individual Edit Menu is the type of MIDI data that the control
has assigned to it. So, if the button/knob is set to a Continuous Controller number then the screen shows:
The types of MIDI data available are:
CC Continuous Controller. Any controller number can be used, however the MIDI standard
defines controller numbers 0, 6, 32, 38, 96, 97, 98, 99, 100, 101 & 120-127 for
specific specialised purposes. These values should not be used unless the consequences
upon the connected MIDI device are appreciated.
NRPN Non-registered Parameter Number.
RPN Registered Parameter Number.
MMC MIDI Machine Control. This can only be selected for buttons.
Note On/Off Note On/Note Off message. This can only be selected for buttons.
Program Change Program Change message. This can only be selected for buttons.
Pitch Bend Pitch Bend. This can only be selected for the X / Y Touchpad.
Aftertouch Aftertouch. This cannot be selected for buttons.
No Contr
ol
The contr
ol will transmit no MIDI when touched. Ther
e are no further menu pages
available if this option is selected.
T
o change between these types of MIDI data, simply rotate the DATA encoder. Once the type of MIDI data is
selected, the remaining settings for that MIDI control can be defined by accessing the additional individual Template
Edit menu pages. This is done using the PAGE UP/DOWN buttons to the right of the LCD screen.
The above MIDI data may be applied to EACH of the 11 knobs or 11 buttons for Groups A and B, the Pitch/Mod
Joystick, any of the 4 quadrants of the X/Y Touchpad and a sustain pedal (if one is attached).
Control Type:
XXX CC
To Next Page
Loading...
