Novation Xio - Page 46

Template Individual Edit ‘Program Change’ Menu
Page 1 is the same for all Template Edit Menus (Control Type – see CC Menu for details).
Page Number Page Name DATA Encoder selects…
2 Program Change Program Change Value
3 MIDI Channel MIDI Channel for this control
4 MIDI Ports Port routing for the control
5 Control Naming Name of Control
Here is a detailed breakdown of the unique page(s) of the individual Template Edit Menu once ‘Program
Change’ has been selected on Page 1. Note that Program Change can only be selected for buttons:
Edit Menu Page 2 – Program Change Value Selection
This page allows a Program Change data value to be selected by rotating the DATA encoder to make XXX a
value of between 0 and 127. Be aware that some MIDI devices number Programs from 1 to 128 instead of
0 to 127; in this case, the number 1 (on the MIDI device) will correspond to 0 (on the Xio) and 128 (on the
device) to 127 (on the Xio).
When set to a Program Change type control, a button will only function in Momentary mode.
That is, when pressed the Program Change data will be transmitted. When released, a Note off will be
transmitted?
The r
emaining pages of the Menu for Pr
ogram Change messages are identical to the corresponding pages
for CC data (see previous pages).
Prog Chg Value:
XXX