Novation Xio - Page 60

Albino 2
Layout
Group A
Knobs 1 and 2: Osc 1 Cent and Volume
Knobs 3-5: Filter 1 Frequency, Resonance and Mod Depth
Knob 6: LFO 1 Rate
Knobs 7-10: Amp Attack, Decay, Sustain and Release
Knob 11: Master Volume
Buttons 1 and 2: Osc 1 On/Off and Type
Buttons 3 and 4: Filter 1 Mode and Type
Buttons 5 and 6: LFO 1 Waveform and Mono
Buttons 7 and 8: Amp Env Type and Loop
Button 9: No control
Buttons 10 and 11: Filter 1 On/Off, Filter 2 On/Off
Group B
Knobs 1 and 2: Osc 2 Cent and Volume
Knobs 3-5: Filter 2 Frequency, Resonance and Mod Depth
Knob 6: LFO 1 Delay
Knobs 7-10: Mod Attack, Decay, Sustain and Release
Knob 11: Arp Length
Buttons 1 and 2: Osc 2 On/Off and Type
Buttons 3 and 4: Filter 2 Mode and Type
Buttons 5 and 6: LFO 1 Waveform and Ret On/Off
Buttons 7 and 8: Mod Env Type and Loop
Button 9: No control
Buttons 10 and 11: Arp On/Off and Mode
Touchpad has Filter 1 Frequency and Resonance assigned to it throughout.
Setup
To allow control of Albino 2 using the Xio, load an instance of Albino 2 into your sequencer and select 'Load'
from the Easy Controller Setup (ECS) menu (click on the button labelled 'ECS' in the Albino 2 window). Then
locate and open the file 'XIO_ALBINO_2.MOD', found in the Albino Template folder on the Resources disk.