Once the top Audio LED is active, the knobs can be used to adjust the Input levels accordingly, as follows:
Line-Level/Instrument Recording
To record a line-level signal (Input 2), connect a 1/4” Jack into the rear panel socket and set the level of the
Input using the corresponding knob on the front panel (in AUDIO mode as detailed above). If wanting to
record an instrument like a guitar, then the signal can be plugged in directly to Input 2 and recorded by
exactly the same means.
A
udio Inputs 1 and 2 Level Audio Inputs 1 and 2 PanningPress to activate Audio mode
(
upper LED will light). Press
a
nd hold if in Synth mode
B
lend between Levels of
I
nputs and Playback tracks
(
Latency-free monitoring)
To Next Page
Loading...
