12
Empty and Clean Filter Bag
Tilt the filter bag cover forward to expose the filter
bag. (See Fig 2 Item 11.)
Remove the filter bag. (See Fig 2 Item 24.)
Empty the filter bag daily or when it is
approximately one-half (1/2) full.
Pad Installation / Changing
There is a wide range of pads available for many
different burnishing applications. Consult your local
NSS authorized distributor for application
recommendations.
Park the machine on a level surface.
Lift the front of the machine up to the 90 degree
position to view the pad driver and pad.
Make sure that the correct pad (15/16" to 1" [22mm
to 25.4mm]) X 27" [68.6 cm] is being installed.
Remove the center hole of the pad and place the
pad flat on the floor. Step on the center of the pad
to compress the edges around the center hole.
This allows for easier installation of the pad
centering cup.
With the machine in the pad changing position,
carefully center the pad on the driver.
Caution: Pads must be installed concentric
(evenly aligned) with the outside edge of the
pad driver. Failure to follow these
precautions will cause excessive machine
vibration, a reduction in pad life and produce
unsatisfactory burnishing results.
Place the pad grabber in the center hole of the pad
and push on the pad grabber until the spring clip
has clicked twice.
Caution: Failure to install the pad grabber
tightly may allow the pad grabber and/or pad
to be thrown from the driver.
Never: Leave the machine sit with a
used pad installed. This can cause the
pad driver to warp.
Weekly Maintenance (Every 25 Hrs)
Verify all daily maintenance has been performed.
Check the water level in batteries
Check the water level in each of the three cells in
each battery and add distilled water as required to
level specified by battery manufacturer.
Check and verify that all battery connections are
clean and tight.
Wipe machine down with a damp cloth.
NEVER spray this machine with water or any
liquids.
To Next Page
Loading...
