13
Inspect Flexiwall shield
Inspect the Flexiwall Shield for dents around the
outside edge and cracks in the plastic.
Check that the Brush and Retaining Band are
properly installed.
Remove dirt build up on the brush along the
bottom of the Flexiwall Shield.
A damaged Flexiwall Shield Assembly will greatly
reduce dust control capabilities of the machine.
Monthly Maintenance (Every 100 Hrs)
Verify that all daily and weekly maintenance has
been performed.
Equalize your batteries (Flooded only).
The batteries should be equalized once every 30
days for maximum battery runtime and life.
To equalize the batteries:
Plug in the charger, and fully charge the batteries.
Unplug the charger from the wall outlet, then plug it
back in.
The charger will run holding the batteries at a
constant voltage, and equalizing each cell.
Clean the Burnishing Head and Motor
With compressed air, blow any dust and buildup
from the burnishing head and motor.
Maximum air pressure 100 PSI.
Wipe down with damp cloth.
Inspect the machine
Inspect the machine components for wear, loose
fasteners, or damage. Pay special attention to all
pivot points and moving parts.
Call an authorized NSS service center for repairs.
Drain the Battery Tray
Check the Battery Tray Drain Hose located under
the machine for liquid level on a monthly basis.
Spilled liquids from the battery compartment area
are collected in a tray under the batteries. The tray
can be drained using the hose under the machine
as shown above.
IMPORTANT: Drain all liquids into an approved
container and dispose of according to your local
and federal regulations.
To Next Page
Loading...
