Parts List │ Tx I&O Manual
Heat Exchanger Support Rail, c/w screws (Tx101 ASME)
Heat Exchanger Support Rail, c/w screws (Tx151 & Tx151C ASME)
Heat Exchanger Support Rail, c/w screws (Tx200 & Tx200C)
Heat Exchanger Support Front Clip (all Tx models)
Gas Valve to Venturi Gasket (Tx51-151 & Tx151C)
Gas Valve to Venturi Gasket & Screws (Tx200 & Tx200C)
Elbow, Street, Brass, ¾” (Tx51-200)
Elbow, Brass, ¾ (Tx151C & Tx200C – post s/n 72000)
DHW Temperature/Flow Sensor, VFS (Tx151C & Tx200C)
O-ring (large), Combi Block Inlet/Outlet, 4 x 17 (Tx151C & Tx200C)
Retaining Clips, Combi Block Inlet/Outlet (Tx151C & Tx200C)
Plug, Dome, 7/8” (all Tx models)
Tx151C DHW Fitting Set, ¾” NPT, c/w O-rings (Tx151C)
Tx200C DHW Fitting Set, ¾” NPT, c/w O-rings (Tx200C)
CH Fittings (c/w O-ring), Combi Block, ¾” NPT (Tx151C & Tx200C)
Retaining Clip, Air Vent Adapter (all Tx models)
Gas Valve Harness (Tx200 & Tx200C)
Rocker Power Switch (all Tx models)
Relief Valve, 30 PSI (all Tx models)
Pressure Gauge, Bottom Stem Mount, 60 PSI (Tx51-200)
Pressure Gauge, Back Mount, 60 PSI (Tx151C – pre s/n 72000)
Pressure Gauge, Top Stem Mount, 60 PSI (Tx151C & Tx200C – post s/n 72000)
3” Bird Screen (all Tx models)
Natural Gas to LP Conversion Instructions (Tx51-151 & Tx151C)
Natural Gas to LP Conversion Instruction (Tx200 & Tx200C)
LP Conversion Decal (Tx51-151 & Tx151C)
LP Conversion Decal (Tx200 & Tx200C)
Y-Strainer, Brass, ¾”, 100M Screen (Tx151C & Tx200C)
Compression Gasket, Rubber (Tx151C & Tx200C)
Low Loss Header Pipe, FIDT (Tx151C – pre s/n 72000)
Low Loss Header Pipe, FIDT (Tx151C & Tx200C – post s/n 72000)
Wall Mount Bracket, L-shaped (all Tx models)
IWC - Integrated Water Control, Grundfos (Tx151C & Tx200C)
NG to LP Conversion Kit, Tx51 (2+1)
NG to LP Conversion Kit, Tx81 (3+1)
NG to LP Conversion Kit, Tx101 (4+1)
NG to LP Conversion Kit, Tx151 & Tx151C (5+1)
NG to LP Conversion Kit, Tx200 & Tx200C (7+2)
To Next Page
Loading...
