Numark NV User Manual

VirtualDJ 8 – Numark NV
10
39. SCRATCH. Press this button to set the Jogwheel to Vinyl (Scratch) or CD (Bend)
mode. In Vinyl mode, use the outer part of the Jogwheel to bend (temporary speed
up – slow down the tempo of the track).
40. JOG. Touch sensitive jogwheel. Use the jogwheel to scratch (if Vinyl mode is
selected) or pitch bend. The Jogwheel also offers Loop In and Loop Out point
adjustment (see Manual Loop Pads mode)
41. PITCH. Adjust the track's playback speed (tempo). The white LED next to the fader
will light up when the unit’s fader is set at 0%. The Red Up and Down Arrow LEDs
will lit if the pitch position of the unit and the actual pitch of the software do not match,
to indicate the direction you need to move the hardware fader in order to catch the
software one.
42. REVERSE/BLEEP. While this button is held, the playback of the track will be
reversed. When released the track will resume normal playback from where it would
have been if you had never engaged the Bleep function (i.e., as if the track had been
playing forward the whole time).
Hold SHIFT down and then use this button to reverse the playback of the track.
Repeat to resume normal playback from wherever the Audio Pointer stops.
43. SLIP MODE. Press this button to activate the Slip mode. Several software functions
(such as Jogwheel movements, HotCues and Loops) will apply temporary on the
track, and the track will return to the position it would have been when those
functions are not triggered.
44. BEATS ENC. This knob moves forward/backwards the track by 1 beat.
Hold SHIFT down and then use this knob to adjust the Key of the loaded track. Hold
SHIFT and then push the knob to reset the Key of the track to its original value.
45. TOUCH EQ/FX (Left side).
Press this button to enable the FX TOUCH Mode. On this Mode the Touch
Capacitors of the FX knobs trigger the Effects while touched.
Press and hold SHIFT and then this button to enable the EQ/FX TOUCH Mode. Led
will blink to indicate this mode. On this Mode, the Touch Capacitors of the FX knobs
(35) trigger the Effects while touched (same as FX TOUCH Mode), and additionally
the EQ Touch Capacitors will kill the corresponding frequencies while touched.
45. FILTER MODE (Right side). Press this button to enable the FILTER ROLL Mode
(LED lights on). Holding SHIFT down, the button enables the FILTER FX Mode (LED
Flashes). See FILTER (24)
E. EFFECTS
Both Effect units (on the left and right side) offer 3 different modes and control for the
Effects applied on the corresponding deck or Master.
Hold SHIFT down and then press the BEAT (46) button to toggle between the Single FX
and Multi FX effects mode. Use the MASTER FX A and B buttons (31) to assign the left (A)
or right (B) Effect unit to Master FX Effect mode.

Numark NV Specifications

General

Platter size	5 \
Product color	Black
Platter backlight	Yes
Built-in optical drive	-
Number of scratcher platters	2
USB version	2.0
Apple docking compatibility	Not supported
Power supply type	AC
Cables included	AC, USB