Hold SHIFT down and then press one of the lower Pads to load the Saved Loop, but also
jump to that position.
Note that VirtualDJ will always try to use the next empty/available Slot, so if Slot 2 is empty
and the Pad Nr3 is pressed to save the Loop, the led of the Pad Nr2 will lit to indicate that
the Slot 2 is used.
Use the PARAMETER < and > (38) buttons to half and double the size of the triggered
Loop.
Press the SAMPLER mode button to set the PADs to Sampler mode.
Each one of the 8 pads triggers a
sample (1 to 8) from the selected
Sampler Bank of VirtualDJ.
The leds of the Pads will
automatically get the assigned
color of each sample (dark when
off, bright when playing).
Press the pads to trigger a
sample. Depending on the
selected trigger mode, use SHIFT
and the same pads to stop the
sample.
Use the PARAMETER < and > buttons (38) to select the previous and next Sampler Bank.
Hold SHIFT down and then use the same PARAMETERS buttons to select the previous/next
Trigger Pad mode (on/off, hold, stutter, and unmute)
Hold the SAMPLER mode button down and then use the BEATS encoder (44) to adjust the
Master Output Volume of the Sampler.
Hold SHIFT down and then press the SAMPLER mode button to record/stop recording the
deck to a new Sample (led will blink fast while recording).
To Next Page
Loading...
Need help?
General
