Numark NV - Pad Controls: Slicer; Sampler Velocity Mode; Slicer Mode

VirtualDJ 8 – Numark NV
20
Sampler Velocity mode
While the Sampler mode is selected, press the same SAMPLER mode button again to set
the PADs to Sampler Velocity mode (led will blink).
Same as the Sampler mode, each
one of the 8 pads triggers a sample
(1 to 8) from the selected Sampler
Bank of VirtualDJ, with the
difference that the Output Volume
of each sample is determined by
the strength the Pad was initially
pressed.
Press the pads to trigger a
sample. Depending on the
selected trigger mode, use SHIFT
and the same pads to stop the
sample.
The functionality of the PARAMETER buttons (38) is the same as in the Sampler mode.
Tip: To return all samples to their maximum values after the Velocity mode is used, select the next or
previous available bank and then select the current again.
Slicer mode
Press the SLICER mode button to set the PADs to Slicer mode.
The 8 Pads represent 8 sequential
slices in the Beat Grid. The playing
Slice is represented by the currently
blue lit pad. The blue light will "move
through the pads" as it progresses
through each eight-Slice phrase.
Press a pad to repeat that Slice (hold
it down if you want to keep looping it).
Once the Pad is released the track will
continue to play from the position it
would have been if the pad was never
pressed.
Use the PARAMETER < and > buttons (38) to adjust the length of the Loop applied to the
slice. Press SHIFT and then use the same PARAMETERS < and > buttons to adjust the
step of the Slices.