Numark NV - Pad Controls: HotCues; HotCues Mode; HotCues Loop Mode

VirtualDJ 8 – Numark NV
16
Pads
Pads (35) offer 10 different modes, depending on the PAD MODE SEL buttons (36). Press
the same PAD MODE button again to access the additional mode (the LED will blink as
an indication).
HotCues mode
Press the CUES mode button to set the PADs to HotCue mode.
Each one of the 8 pads assigns a Hot Cue
Point (1 to 8) or returns the track to that Hot
Cue Point.
When a Hot Cue Button is unlit, you can
assign a Hot Cue Point by pressing it at the
desired point in your track. Once it is
assigned, the Hot Cue Button will light up red.
Hold SHIFT and then press any of the pads to
delete its assigned Hot Cue Point.
Use the PARAMETER < and > buttons (38) to jump to the next or previous HotCue.
HotCues Loop mode
Press the CUES Mode button twice (or once if the selected mode was HotCues) to set the
Pads to HotCue Loop mode (the led of the CUES button will blink).
Each one of the 8 Pads assigns a Hot
Cue Point or returns the track to that Hot
Cue Point, but in both cases, it also
triggers a Loop while the Pad is
pressed.
The currently selected length will be used
for the triggered Loop
Press and hold SHIFT and then press a
pad to delete its assigned Hot Cue Point.
Use the PARAMETER < and > buttons (38) to half and double the size of the applied
Loop.