Always ensure that the machine is switched o prior to charging.
!!
The battery meter displays the charge level of the batteries;
when fully charged, all meter lights are illuminated.
As the machine is used and the batteries are discharged,
the meter lights will go out from right to left.
If the battery-charge level is allowed to discharge to the
point that only the red light remains illuminated,
the operator must consider charging the machine.
When the machine is getting close to empty the second light from the
end starts to ash, the operator should then take the machine to a
suitable charging point.
The large capacity gel batteries are sealed for life and are totally maintenance free.
The on-board charger automatically monitors the charging process and will switch o when the batteries are fully charged.
Insert the charging lead required for your country into the charging point.
The machine charging point is located to the rear of the machine under the control panel.
Connect to a suitable power supply.
Once mains power is connected the red charging indicator will illuminate.
To ensure a full charge, the machine should be left for a period of 8 hrs.
Once fully charged, disconnect the charging lead from both the power supply and the machine.
ALWAYS ENSURE THE MACHINE IS
SWITCHED OFF PRIOR TO CHARGING.
Recharge batteries after each use,
regardless of machine operation time.
The machine charging point is located to the
rear of the machine under the control panel.
Remove Isolator Plug and connect your
external charger.
Ret Isolator Plug before operating the
machine.
Note: Only use the recommended charger and leads. Contact Numatic International Ltd for recommended charger and leads.
To Next Page
Loading...
