20
On-the-fl y programming
This feature allows a user the ability
to change programs anytime during
a workout. Note, a workout must be
60 seconds in length and .03 miles
(.05 km) if you wish to transfer the
workout data to another program;
otherwise, it starts from zero. Note:
This feature is not available for the
exercise protocol programs.
Battery saver mode
To save the battery during inactivity,
the product will go into battery saver
mode after two weeks to preserve the
battery. To remove it from this state,
simply step very quickly. Although
this feature is automatic, it may also
be manually placed into this state
when the unit is off by pressing and
holding any button for 10 seconds.
Average button
When the average button is pressed,
the cumulative workout averages
are displayed on the console screen
for 6 seconds. The console will
automatically return to the workout
screen or you may press the continue
workout soft key button to return to
the workout screen sooner.
Load 0 (zero)
Load 0 gives an even lower workload
level than Load 1. Load 0 only
displays and works when the unit
is plugged into a power outlet and
provides the absolute lowest workload
setting available.
Flash Device Programming
Capability
To upgrade to the latest software
version, download the latest version to
a fl ash device and insert into back of
console while T5 unit is off. Turn unit
on and the reprogramming process
will begin automatically. Do not
remove the fl ash device until prompts
tell you reprogramming is complete.
How to Use
Access all information from the how
to use button available during any
workout. This button allows a user
to fi nd out how to use the product.
Note, context sensitive i button is also
available.
Additional Features
To Next Page
Loading...
