37
US FCC Compliance & IEC/EN 55011 Compliance
US FCC Compliance Statement:
Note: This equipment has been tested and found to comply with the limits
for a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can generate radio frequency energy and, if not installed and used in
accordance with the installation instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
may not occur in a particular installation. If the equipment causes harmful
interference to radio or television reception, which can be determined by
turning this equipment off and on, the user is encouraged to try and correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit which is different from that
to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
IEC/EN 55011 Compliance Statement:
This device complies with IEC/EN 55011, Group 1, Class B. Group 1 contains
all ISM equipment in which there is intentionally generated and/or used
conductively coupled radio-frequency energy which is necessary for the
internal functioning of the equipment itself. Class B equipment is suitable
for use in domestic establishments and in establishments directly connected
to the low voltage power supply network which supplies buildings used for
domestic purposes.
To Next Page
Loading...
