Chapter 6. Using the Baseboard
Management Controller
(BMC)
The NVIDIA DGX™ B200 system contains a baseboard management controller (BMC) that monitors
and controls various hardware devices on the system, including system sensors and other parameters.
6.1. Connecting to the BMC
Here are the steps to connect to the BMC on a DGX B200 system.
Before you begin, ensure that you connect the BMC network interface controller port on the DGX
system to your LAN.
1. Open a browser within your LAN and enter the IP address of the BMC in the location.
The BMC is supported on the following browsers:
▶ Internet Explorer 11 and later
▶ Firefox 29.0 (64-bit) and later
▶ Google Chrome 7.0.3396.87 (64-bit) and later
2. Log in.
The BMC dashboard opens.
39
To Next Page
Loading...
