Nvidia Spectrum-2 SN3420 - Page 110

NVIDIA Spectrum-2 SN3000 1U and 2U Switch Systems Hardware User Manual 109
Step 2. Congure a serial terminal program (for example, HyperTerminal, minicom, or Tera
Term) on your host PC with the settings described in the table below. Once you perform
that, you should get the CLI prompt of the system.
Serial Terminal Program Conguration
Parameter Setting
Baud Rate 115200
Data bits 8
Stop bits 1
Parity None
Flow Control None
Step 3. Login as admin and use admin as password. On the rst login, the NVIDIA Onyx
(MLNX-OS) conguration wizard will start.
Step 4. To congure network attributes and other initial parameters to the system, follow
the conguration wizard as shown in the Conguration Wizard Session table below.
Conguration Wizard Session
Wizard Session Display Comments
NVIDIA conguration wizard
Do you want to use the wizard
for initial conguration? yes
You must perform this conguration the rst time you
operate the system or after resetting the system. Type
‘y’ and then press <Enter>.
Step 1: Hostname? [switch-1]
If you wish to accept the default hostname, press
<Enter>. Otherwise, type a dierent hostname and
press <Enter>.
Consol
e RJ45
images/download/thumbnails/2487220152/image2018-11-
14_10-2-54-version-1-modicationdate-1570470316753-
api-v2.png
Ethern
et MGT
images/download/attachments/2487220152/image2018-
11-13_16-13-1-version-1-modicationdate-
1570470316657-api-v2.png