Nvidia Spectrum-2 SN3420 - Page 111

NVIDIA Spectrum-2 SN3000 1U and 2U Switch Systems Hardware User Manual 110
Wizard Session Display Comments
Step 2: Use DHCP on mgmt0
interface? [no] yes
Perform this step to obtain an IP address for the
system. (mgmt0 is the management port of the
system).
If you wish the DHCP server to assign the IP address,
type ‘yes’ and press <Enter>.
If you type ‘no’ (no DHCP), then you will be asked
whether you wish to use the ‘zeroconf’ conguration or
not.
If you enter ‘no’ (no Zeroconf), you must enter a static
IP, and the session will continue.
Step 3: Enable IPv6? [yes]
The management interface will be able to use IPv6
addresses.
If you enter "no" (no IPv6), you will automatically be
referred to Step 6.
Step 4: Enable IPv6 auto-
cong (SLAAC) on mgmt0
interface? [no]
This turns on auto-conguration of the IPv6 addresses.
This is unsuitable for DHCPv6.
Step 5: Enable DHCPv6 on
mgmt0 interface? [no]
To enable DHCPv6 on the MGMT0 interface.
Step 6: Admin password (Press
<Enter> to leave unchanged)?
<new_password>
Step 6: Conrm admin
password? <new_password>
To avoid illegal access to the machine, please type a
password and then press <Enter>. Then conrm the
password by re-entering it. Note that password
characters are not printed.
You have entered the following
information:
<A summary of the
conguration is now
displayed.>
To change an answer, enter
the step number to return to
or hit <enter> to save changes
and exit.
Choice: <Enter>
Conguration changes saved.
The wizard displays a summary of your choices and
then asks you to conrm the choices or to re-edit
them.
Either press <Enter> to save changes and exit, or enter
the conguration step number that you wish to return
to.
Note: To re-run the conguration wizard, run the
command “conguration jump-start” in Cong mode.
The table below shows an example of static IP conguration for mgmt0 interface.
Conguration Wizard Session - Static IP Conguration