Nvidia Spectrum-2 SN3420 - Page 112

NVIDIA Spectrum-2 SN3000 1U and 2U Switch Systems Hardware User Manual 111
Step 5. Before attempting a remote (for example, SSH) connection to the system, check
the mgmt0 interface conguration. Specically, verify the existence of an IP address. To
check the current mgmt0 conguration, enter the following command:
Mellanox configuration wizard

Do you want to use the wizard for initial configuration? yes

Step 1: Hostname? []
Step 2: Use DHCP on mgmt0 interface? [yes] no
Step 3: Use zeroconf on mgmt0 interface? [no]
Step 4: Primary IP address? [for example 192.168.10.4]
10.10.10.10
Mask length may not be zero if address is not zero (interface
eth0)
Step 5: Netmask? [0.0.0.0] 255.255.255.0
Step 6: Default gateway? [for example 192.168.10.1] 10.10.10.255
Step 7: Primary DNS server?
Step 8: Domain name?
Step 9: Enable IPv6? [yes]
Step 10: Enable IPv6 autoconfig (SLAAC) on mgmt0 interface? [no]
Step 11: Admin password (Enter to leave unchanged)?

To change an answer, enter the step number to return to.
Otherwise hit <enter> to save changes and exit.
Choice:
Configuration changes saved.

To return to the wizard from the CLI, enter the “configuration
jump-start”
command from configure mode. Launching CLI...
switch01 (config) # show interfaces mgmt0