Nvidia Spectrum-2 SN3420 - Page 17

NVIDIA Spectrum-2 SN3000 1U and 2U Switch Systems Hardware User Manual 16
This equipment should be installed in compliance with local and national electrical codes.
Installation Codes
This device must be installed according to the latest version of the country national
electrical codes. For North America, equipment must be installed in accordance to the
applicable requirements in the US National Electrical Code and the Canadian Electrical
Code.
Battery Replacement
Warning: Replace only with UL Recognized battery, certied for maximum abnormal
charging current not less than 4mA. There is a risk of explosion should the battery be
replaced with a battery of an incorrect type. Dispose of used batteries according to the
instructions. For applicable models: PERCHLORATE MATERIAL - LITHIUM COIN/BUTTON
CELL BATTERY. PLEASE DISPOSE OF PROPERLY. SPECIAL HANDLING MAY APPLY.
UL Listed and CSA Certied Power Supply Cord
For North American power connection, select a power supply cord that is UL Listed and
CSA Certied, 3 - conductor, [16 AWG], terminated with a molded plug rated at 125 V, [13
A], with a minimum length of 1.5m [six feet] but no longer than 4.5m.
For European connection, select a power supply cord that is internationally harmonized
and marked “<HAR>”, 3 - conductor, minimum 1.0 mm2 wire, rated at 300 V, with a PVC
insulated jacket. The cord must have a molded plug rated at 250 V, 10 A.
Installation Codes
This device must be installed according to the latest version of the country's national
electrical codes. For North America, equipment must be installed in accordance to the
applicable requirements in the US National Electrical Code and the Canadian Electrical
Code.
Interconnection of Units
Cables for connecting to the unit RS232 and Ethernet Interfaces must be UL certied
type DP-1 or DP-2. (Note: when residing in non LPS circuit.)
Overcurrent Protection