NXP Semiconductors arm LPCXpresso55S36 - Page 12

NXP Semiconductors
LPCXpresso55S36UM
LPCXpresso55S36 Development Board User Manual
Part identifier Jumper type Description Reference section
JP43 1x3 pin header Target MCU pin PIO0_25 I/O selection jumper:
• Pins 1-2 shorted: Target MCU pin PIO0_25
sends/receives I/O to/from octal flash
memory / external flash memory
• Pins 2-3 shorted (default setting): Target MCU
pin PIO0_25 sends/receives I/O to/from Motor
2 + Arduino socket connector J122
JP44 1x3 pin header Target MCU pin PIO0_3 I/O selection jumper:
• Pins 1-2 shorted: Target MCU pin PIO0_3
sends/receives input/output to/from jumper
JP62
• Pins 2-3 shorted (default setting): Target MCU
pin PIO0_3 sends/receives input/output to/
from Motor 2 + Arduino socket connector
J102
JP62 1x3 pin header Jumper JP44 pin 1 I/O selection jumper:
• Pins 1-2 shorted (default setting): Jumper
JP44 pin 1 sends/receives serial data to/from
octal flash memory / external flash memory
• Pins 2-3 shorted: Jumper JP44 pin 1 sends/
receives I2C/I2S data / analog signal
JP45 1x3 pin header Target MCU pin PIO0_21 I/O selection jumper:
• Pins 1-2 shorted: Target MCU pin PIO0_21
sends/receives input/output to/from octal flash
memory / external flash memory
• Pins 2-3 shorted (default setting): Target MCU
pin PIO0_21 sends/receives input/output to/
from Motor 2 + Arduino socket connector
J102
JP64 1x3 pin header Target MCU pin PIO1_29 function control
jumper:
• Pins 1-2 shorted: Target MCU pin PIO1_29
sends/receives serial data to/from octal flash
memory / external flash memory
• Pins 2-3 shorted (default setting): Target MCU
pin PIO1_29 acts as a GPIO pin
JP65
1x3 pin header Target MCU pin PIO1_27 function control
jumper:
• Pins 1-2 shorted: Target MCU pin PIO1_27
sends/receives serial data to/from octal flash
memory / external flash memory
• Pins 2-3 shorted (default setting): Target MCU
pin PIO1_27 acts as a GPIO pin
JP66 1x2 pin header Target MCU pin PIO1_16 I/O enable jumper:
• Open (default setting): Target MCU pin
PIO1_16 input/output is disabled
• Shorted: Target MCU pin PIO1_16 sends/
receives serial data to/from octal flash
memory / external flash memory
Table 6. LPCXpresso55S36 jumpers...continued
LPCXpresso55S36UM All information provided in this document is subject to legal disclaimers. © NXP B.V. 2022. All rights reserved.
User manual Rev. 2 — 5 September 2022
12 / 46