NXP Semiconductors arm LPCXpresso55S36 - Motor 2 Control + Arduino Socket

NXP Semiconductors
LPCXpresso55S36UM
LPCXpresso55S36 Development Board User Manual
J9
BEMF_A/CUR_A 1
2 NC
BEMF_B/CUR_B 3
4 NC
6 NC
BEMF_C/CUR_C 5
VOLT_DCB 7
8 NC
CUR_DCB 9
10 NC
BEMF_A_AUX 11
12 NC
BEMF_B_AUX 13
14 GND
BEMF_C_AUX 15
16 I3C0_PUR
NC 17
18 I3C0_SDA
NC 19
20 I3C0_SCL
J12
NC 1
2 DAC1_Out
HALL_C/ENC_I 3
4 DAC0_Out
6 NC
NC 5
NC 7
8 P0_22
NC 9
10 NC
NC 11
12 NC
RSHUNT_CURDCB_P 13
14 GND
RSHUNT_CURDCB_N 15
16 VREFOut
J10
1 HALL_B/ENA_B
NC 2
3 HALL_A/ENA_A
IOREF 4
NC 6
5 PWM_CB
7 PWM_CT
3V3 8
9 PWM_BB
5V0 10
11 PWM_BT
GND 12
13 PWM_AB
GND 14
15 PWM_AT
VIN1_EXT 16
J13
1 RSHUNT_CURA_PNC 2
3 RSHUNT_CURA_N
NC 4
NC 6
5 RSHUNT_CURB_P
7 RSHUNT_CURB_N
NC 8
9 RSHUNT_CURC_P
NC 10
11 RSHUNT_CURC_N
NC 12
Legends:
Motor control
MCU pins
Figure 13. Motor 1 control + unused MCU pin socket connector pinouts
Jumper JP58, which is placed between signals on pins 16 and 18 of connector J9, is
used to enable/disable pullup resistor control for I3C master.
2.13.2 Motor 2 control + Arduino socket
The Motor 2 control + Arduino socket allows communication with the following modules of
the target MCU:
• FlexPWM1 module of motor control subsystem
• Analog-to-digital converter (ADC) modules, ADC0 and ADC1
• HS SPI controller
The Motor 2 control + Arduino socket is pin-compatible with an Arduino UNO board. The
socket includes the following four connectors:
• J132 (2x6 position receptacle)
• J102 (2x8 position receptacle)
• J92 (2x10 position receptacle)
• J122 (2x8 position receptacle)
The figure below shows the pinouts of Motor 2 control + Arduino socket connectors. Odd
pins (inner side pins) of the socket are used for motor control. Even pins (outer side pins)
of the socket provide connection with an external Arduino board.
LPCXpresso55S36UM All information provided in this document is subject to legal disclaimers. © NXP B.V. 2022. All rights reserved.
User manual Rev. 2 — 5 September 2022
31 / 46