Table 2. Boot mode pin settings (continued)
00 Boot From Fuses
01 Serial Downloader
10 Internal Boot
11 Reserved
Typically, the internal boot is selected for normal boot, which is configured by external BOOT_CFG GPIOs. Table 3 shows the
typical Boot Mode and Boot Device settings.
Table 3. Typical boot mode and boot device settings for RT1060
SW7-1 SW7-2 SW7-3 SW7-4 Boot Device
OFF ON ON OFF Hyper flash
OFF OFF ON OFF QSPI flash
ON OFF ON OFF SD card
For more information about boot mode configuration, see the System Boot chapter of the MIMXRT1060 Reference
Manual.
For more information about MIMXRT1060 EVK boot device selection and configuration, see the main board
schematic.
NOTE
Table 4. Typical boot mode and boot device settings for RT1064
SW7-1 SW7-2 SW7-3 SW7-4 Boot Device
OFF OFF ON OFF QSPI flash
ON OFF ON OFF SD card
2.3 Power tree
A DC 5 V external power supply is used to supply the MIMXRT1060/1064 EVK board at J2, and a slide switch SW1 is used to
turn the Power ON/OFF. J41 and J9 is used to supply the EVK board.
Table 5 lists different J1 jumper settings for different power supply.
Table 5. Jumper settings for power supply
Power Supply J1 Setting
J2 1-2
J9 3-4
J41 5-6
The power tree is shown in the following figure.
NXP Semiconductors
Specifications
MIMXRT1060/1064 Evaluation Kit Board Hardware User's Guide, Rev. 0, 06/2020
User's Guide 8 / 19
To Next Page
Loading...
Need help?
General
